The Varitube VT510 V2 is here! A Bullet Proof Connector:
- NO Need to disassemble for soldering
- NO Threaded insulators to strip
- NO max wire gauge restrictions
- Solder before or after installation
Only 11.5mm long - note you need an additional 2.5mm-3mm to allow movement within the installation
Note - Properly adjust the T-Nut by loosening or tightening it such that the small pin is flush with the bottom of the slot in the T-Nut on the bottom of the connector ... This allows the top insulator to properly adjust and seat with the Atomizer providing smooth operation. Pre-loading the spring with an over tightened T-Nut may result in 'ratchety' movement while installing an atomizer ... Adjust the T-Nut prior to soldering!
Ultra low profile shoulder, self-adjusting spring loaded center pin, brass backer nut for solid and secure installation.
Made of Stainless, Brass, & High Temp insulating material this connector is perfect for box mods and the discerning modder!
- The spring carries no electrical load!
- 22mm with Air Channels
- Only 1mm thick landing pad
- Made of Stainless with High Temp Insulator, and brass - rated for 450F degrees continuous service
- Assembled connector length - 11.5mm - extends to about 14mm with atomizer installed
- Body threading - M10x0.5 - 10mm diameter ... about 3/8"
- Ring Terminal for ground connection included
- Does NOT need to be disassembled for soldering!!! Huge productivity gain! Can be soldered after install as well if desired. Only adjustment needed is to make sure the bottom T-Nut is not over tightened prior to soldering.
- Properly adjust the T-Nut by loosening or tightening it such that the small pin is flush with the bottom of the slot in the T-Nut on the bottom of the connector ... This allows the top insulator to properly adjust and seat with the Atomizer providing smooth operation. Pre-loading the spring with an over tightened T-Nut may result in 'ratchety' movement while installing an atomizer ... Adjust the T-Nut prior to soldering!
Ring Terminals Are Included
